How To Fix Timber Balustrades and Hand Rails On An Upper Family Room
Posted: Tuesday, October 20, 2009
by Andrew Karundu
http://www.karundu.com
Family rooms are resting living areas usually located on upper floors in a home. This rooms are are used for watching television. This areas do not have walls on the side next to the stair well. This requires railings and balustrades to be fixed on this part of the room without walls. The balustrades are fixed and blended with the floor finish. The method of anchoring to the abutting wall and floor is crucial to the strength of the railings.
The family room timber balustrades are fixed onto a four by two timber screwed into the concrete. This timber is laid on the four side to have a rise of two inches. It is drilled and screwed into the concrete along the edge of the stair well. The balusters are made with a steel dowel that will be screwed onto the four by two flat timber. This balusters are spaced at one foot center to center. They are there inches thick. The hand rail is fixed on top.
The height of the timber baluster is three feet. The hand rail is fixed into the wall at least three inches inside. The length is the same as that of the stair well. Once the hand rail is in place, the railing boards are then fixed. This are six by one inch thick. They are spaced at eight inches center to center. After they are in place, varnishing can be done to the desired effect. After this wall and floor finishes are then carried out as desired.
Andrew Karundu Is A Building Economist, Providing Home Based Solutions To Fixing, Repairing, Remodeling And Redesigning Homes. He Uses Simple Tried And Tested Methods To Improve Family Lifestyles.Visit His Site Here For Adequate Information On Most HOME IMPROVEMENT SOLUTIONS .
This Article has been viewed 131 times. (Not updated in real-time.)
No comments yet.We want your comments! If you can read this, you don't have javascript enabled, so you can't use this comment system. Please enable javascript.