How To Make a Glass Fan Light In a Timber Door Frame



Posted: Saturday, October 10, 2009

by
http://www.karundu.com

Fan lights are found on top of a long door frame. They are usually made of glass with a vent of one inch above the glass. They allow light and air movement in and out of a room. They are normally fitted on door ways of all rooms except wash rooms and lavatories. In rooms where the corridor has no adequate light, they assist by allowing it into the passage. This light is from windows in the rooms. The glass is fixed into a rebate using timber beading's nailed to the door frame.

The fan light can be of made of clear sheet or frosted glass. This will depend on the amount of light intended on the passage and the door location. The vent above the glass can be covered with a gauze wire. This will stop the insects and flies from crossing from the open lobbies into the rooms. The fan light can be introduced on door frame existing in a house. Where door frame heights are greater than ten feet, a fan light can be used. This will also give good door frame aesthetics.

The fixing of the glass fan light starts with measuring the size of the opening above the door. The glass is then cut, leaving a one inch gap at the top. The glass should be cut leaving space at the bottom and side of the frame. This will allow it to slide into the rebate of the frame without getting stuck. The beadings to be used should also be measured and cut at forty five degrees at the ends. This will allow a smooth joint at the corners. The wire nails to be used should not break the beading when being hammered in.

When the glass is slid into the rebate, panel pins are hammered into three spots round. This are for ensuring the glass does not rattle when the door is closed. Also in the case of wind gushing into the room when windows are opened. The beading is then hammered onto the rebate also using the panel pins. The beading should fit flush with the rebate. After it is fixed, painting of this timber is then carried out. This should match the door frame paint. After apply three coats and it dries, the glass is cleaned to remove any paint marks.

Andrew Karundu Is A Building Economist, Providing Home Based Solutions To Fixing, Repairing, Remodeling And Redesigning Homes. He Uses Simple Tried And Tested Methods To Improve Family Lifestyles.Visit His Site Here For Adequate Information On Most HOME IMPROVEMENT SOLUTIONS .

This Article has been viewed 218 times. (Not updated in real-time.)
No comments yet.
We want your comments! If you can read this, you don't have javascript enabled, so you can't use this comment system. Please enable javascript.